Abstract：Hall position sensor is with low cost and it can provide a relative accurate position information. On the other hand, it also has drawbacks such as low position resolution; poor speed measurement continuity and serious information lag behind. The Luenberger speed observer takes advantages of motor model and closed loop control theory thus can provide favorable speed and rotational angle feedback signal when under vector control. However, when it comes to the digital control system, due to the fact the sampling period of hall signal is much longer than that of the control period, ideal observed results still cannot be obtained when using conventional observer parameters and structure design method. Based on the analysis for issues of speed observer when under real applications, an effective speed and rotational angle estimation method which combined the reduced-order observer and multi-sampling theory is proposed in this paper, it best take advantage of the real hall signal information and can provide speed and rotational angle estimation results at each digital control period, besides, theoretical analysis prove that an ideal estimation performance can be achieved. The effectiveness of the proposed algorithm is verified through simulation and experiment, which shows the control performance can satisfy the needs of medium and lower standard servo applications.
倪启南, 杨明, 董翔, 刘晓胜, 徐殿国. 基于霍尔位置传感器的PMSM转速观测器状态估算误差抑制方法[J]. 电工技术学报, 2017, 32(17): 189-198.
Ni Qinan, Yang Ming, Dong Xiang, Liu Xiaosheng, Xu Dianguo. State Estimation Error Suppression for PMSM Speed Observer Based on Hall Position Sensor. Transactions of China Electrotechnical Society, 2017, 32(17): 189-198.
[1] Ahn H J, Lee D M. A new bumpless rotor-flux position estimation scheme for vector-controlled washing machine[J]. IEEE Transactions on Industrial Informatics, 2016, 12(2): 466-473. [2] Liu Yang, Zhao Jin, Xia Mingzi, et al. Model reference adaptive control-based speed control of brushless DC motors with low-resolution Hall-effect sensors[J]. IEEE Transactions on Power Electronics, 2014, 29(3): 1514-1522. [3] Dalala Z M, Cho Y, Lai J S. Enhanced vector tracking observer for rotor position estimation for PMSM drives with low resolution Hall-effect position sensors[C]//IEEE International Electric Machines & Drives Conference, Chicago, IL, USA, 2013: 484-491. [4] 董亮辉, 刘景林. 永磁同步电机位置传感器的故障检测和容错控制[J]. 西北工业大学学报, 2016, 34(2): 306-312. Dong Lianghui, Liu Jinglin. Fault detection and fault tolerant control of permanent magnet synchronous motor drives with Hall sensors[J]. Journal of Northwestern Polytechnical University, 2016, 34(2): 306-312. [5] Yoo A, Sul S K, Lee D C, et al. Novel speed and rotor position estimation strategy using a dual observer for low-resolution position sensors[J]. IEEE Transactions on Power Electronics, 2009, 24(12): 2897-2906. [6] Lidozzi A, Solero L, Crescimbini F, et al. SVM PMSM drive with low resolution Hall-effect sensors[J]. IEEE Transactions on Power Electronics, 2007, 22(1): 282-290. [7] Batzel T D, Lee K Y. Slotless permanent magnet synchronous motor operation without a high resolution rotor angle sensor[J]. IEEE Transactions on Energy Conversion, 2000, 15(4): 366-371. [8] Araki M, Yamamoto K. Multivariable multirate sampled-data systems: state-space description, transfer characteristics, and Nyquist criterion[J]. IEEE Transactions on Automatic Control, 1986, 31(2): 145- 154. [9] Araki M, Tomomichi H. Pole assignment by multirate sampled-data output feedback[J]. International Journal of Control , 1986, 44(6): 1661-1673. [10] Kovudhikulrungsri L, Koseki T. Precise speed estimation from a low-resolution encoder by dual- sampling-rate observer[J]. IEEE/ASME Transactions on Mechatronics, 2006, 11(6): 661-670.
2017, Vol. 32 
