Key Techniques in Project Application of Injection Type Active Power Filter
Qi Mingjun1, 3, Luo An1 Liu Dingguo2
1. Hunan University Changsha 410082 China 2. Hunan Electric Power Test and Research Institute Changsha 410007 China 3. Hunan Electric Power Company Changsha 410007 China
Abstract:The fundamental voltage undertaken by the active part of injection type active power filter (ITAPF) is small because the injection circuit in the topology of ITAPF, so it is suitable for suppressing large-capacity harmonic in high voltage power grid. However, in the project engineering, because of the injection circuit, there are some problems such as the contradiction between harmonic voltage undertaken by fundamental resonance circuit should be small and injection ability of harmonic current should be good, the DC-voltage raising of ITAPF, the harmonic compensation precision is low because of phase delay of injection current caused by injection circuit. Based on sufficient analysis, this paper proposes some methods to solve these problems, including optimizing design of injection circuit, controlling DC-voltage adopting PWM rectifier, selective frequency phase compensation control. Simulation and project application results confirm the validity and feasibility of the methods proposed above.
漆铭钧, 罗安, 刘定国. 注入式有源滤波器工程应用的关键技术[J]. 电工技术学报, 2009, 24(3): 195-202.
Qi Mingjun Luo An Liu Dingguo. Key Techniques in Project Application of Injection Type Active Power Filter. Transactions of China Electrotechnical Society, 2009, 24(3): 195-202.