空气中微秒脉冲沿面放电对环氧树脂表面特性影响研究

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (2740 KB)
输出: BibTeX | EndNote (RIS)

摘要为了获得常压条件下绝缘支撑材料环氧树脂的沿面闪络特性,通过微秒脉冲下连续沿面放电对环氧树脂表面造成老化损伤,获得老化前后的环氧树脂沿面闪络特性数据。在脉冲电压幅值为18 kV、频率为100 Hz、电极间距为10 mm的情况下,对环氧树脂表面进行沿面放电老化处理,对不同放电老化时间下的表面形貌、粗糙度及水接触角进行测量,分析放电对材料表面的老化影响。结果发现,放电老化后环氧树脂表面疏松,且有大量突起颗粒形成,表面极易吸水。此外对老化前后的环氧树脂表面进行闪络实验,结果发现,表面闪络电压随老化时间出现先降低后升高的现象。相关实验结果及分析为研究环氧树脂的沿面耐压性能提供了一定的参数数据。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	刘熊
	林海丹
	梁义明
	章程
	谢庆
	邵涛

关键词 ：沿面闪络, 放电老化, 环氧树脂, 微秒脉冲, 表面特性

Abstract：In order to study the surface flashover on epoxy resin (EP) under atmospheric pressure,the surface flashover characteristics are experimented before and after discharges,which was driven by repeated microsecond pulses to cause discharge aging.All EP surface discharge aging experiments are done by an 18 kV pulsed voltage with 100 Hz frequency and 10 mm gap distance.All the surface roughness,water contact angle,morphology of EP surface characteristics are measured after different aging times.It shows that a large number of protruding particles can be found on the PE surface after discharge,which indicates that the surface discharges make the PE surface become porous and hydrophilic.Through the flashover experiments on the aged EP,it is found that the flashover voltage decreased and then increased with time.These experimental results can provide some reference to study the EP surface flashover.

Key words： Surface flashover discharge aging epoxy resin microsecond pulse surface characteristic

收稿日期: 2015-01-20 出版日期: 2015-09-14

PACS:	TM89
	TM315

基金资助:河北省自然科学基金(E2015502081)和国网吉林省电力有限公司科技项目(2014-30)资助。

作者简介: 刘熊男,1988年生,硕士研究生,研究方向为高电压与绝缘技术。林海丹女,1984年生,工程师,研究方向为高电压技术等。

引用本文:

刘熊,林海丹,梁义明,章程,谢庆,邵涛. 空气中微秒脉冲沿面放电对环氧树脂表面特性影响研究[J]. 电工技术学报, 2015, 30(13): 158-165. Liu Xiong ,Lin Haidan ,Liang Yiming ,Zhang Cheng ,Xie Qing ,Shao Tao. Effect of Atmospheric-pressure Microsecond Pulsed Discharges on Epoxy Resin Surface. Transactions of China Electrotechnical Society, 2015, 30(13): 158-165.

链接本文:

https://dgjsxb.ces-transaction.com/CN/Y2015/V30/I13/158

[1] 芦竹茂.环氧树脂绝缘材料中的电树枝研究[D].北京:华北电力大学,2012.
[2] 汤俊萍,张磊,邱爱慈,等.环氧树脂基真空绝缘材料的制备和性能测试[J].强激光与粒子束,2006,18(3):505-508.
Tang Junping,Zhang Lei,Qiu Aici,et al.Development and test of epoxy composite for vacuum insulator[J].High Power Laser and Particle Beams,2006,18(3):505-508.
[3] 潘如政,孙广生,严萍,等.沿面闪络开关研究进展[J].高压电器,2009,45(4):111-114.
Pan Ruzheng,Sun Guangsheng,Yan Ping,et al.Progress in the research of surface flashover switch[J].High Voltage Apparatus,2009,45(4):111-114.
[4] 潘成,申巍,吴锴,等.真空下环氧复合材料耐脉冲电流烧蚀性能[J].电工技术学报,2011,26(11):115-120.
Pan Cheng,Shen Wei,Wu Kai,et al.Ablation resistance of epoxy resin based composite under pulse current in the vacuum[J].Transactions of China Electrotechnical Society,2011,26(11):115-120.
[5] 晏年平,于钦学,任文娥,等.应用理化分析和机械性能分析方法探索HGIS故障原因[J].高压电器,2014,50(7):111-116.
Yan Nianping,Yu Qinxue,Ren Wene,et al.Exploring fault of HGIS with physical-chemical analysis and mechanical performance analysis[J].High Voltage Apparatus,2014,50(7):111-116.
[6] 邵先军,何文林,徐华,等.550 kV GIS现场交流耐压试验下放电故障的定位与分析研究[J].高压电器,2014,50(11):30-37.
Shao Xianjun,He Wenlin,Xu Hua,et al.Location and analysis of discharge failures in 550 kV GIS during field withstanding AC voltage test[J].High Voltage Apparatus,2014,50(11):30-37.
[7] 贾志杰,张乔根,张斌,等.直流下SF₆中绝缘子的闪络特性[J].高电压技术,2009,35(8):1903-1907.
Jia Zhijie,Zhang Qiaogen,Zhang Bin,et al.Flashover characteristic along the insulator under DC voltage in SF₆ gas[J].High Voltage Engineering,2009,35(8):1903-1907.
[8] 丁立健.真空中绝缘子沿面预闪络和闪络现象的研究[D].北京:华北电力大学,2001.
[9] 孟晓波,梅红伟,陈昌龙,等.绝缘子表面流注发展特性受伞裙形状的影响[J].电工技术学报,2013,28(11):278-285.
Meng Xiaobo,Mei Hongwei,Chen Changlong,et al.Influence of curved profiles on characteristics of streamer propagation along the insulator surfaces[J].Transactions of China Electrotechnical Society,2013,28(11):278-285.
[10]Wang Ruixue,Zhang Cheng,Liu Xiong,et al.Microsecond pulse driven Ar/CF₄ plasma jet for polymethylmethacrylate surface modification at atmospheric pressure[J].Applied Surface Science,2015,328:509-515.
[11]Xu Jiayu,Zhang Cheng,Shao Tao,et al.Formation of hydrophobic coating on PMMA surface using unipolar nanosecond-pulse DBD in atmospheric air[J].Journal of Electrostatics,2013,71(3):435-439.
[12]Zhang C,Zhou Y X,Shao T,et al.Hydrophobic treatment on polymethy-methacrylate surface by nanosecond-pulse DBDs in CF₄ at atmospheric pressure[J].Applied Surface Science,2014,311:468-477.
[13]章程,许家雨,邵涛,等.纳秒脉冲放电对聚对苯二甲酸乙二酯憎水改性[J].强激光与粒子束,2014,26(4):147-152.
Zhang Cheng,Xu Jiayu,Shao Tao,et al.Hydrophobic modification of polyethylene terephthalate using nanosecond-pulse dielectric barrier discharge[J].High Power Laser and Particle Beams,2014,26(4):147-152.
[14]牛铮,邵涛,章程,等.空气中纳秒脉冲均匀DBD增加聚合物的表面亲水性[J].高电压技术,2011,37(6):1536-1541.
Niu Zheng,Shao Tao,Zhang Cheng,et al.Hydrophilic improvement of polymers treated by homogeneous nanosecond pulse dielectric barrier discharge in atmospheric air[J].High Voltage Engineering,2011,37(6):1536-1541.
[15]廖瑞金,严家明,杨丽君,等.局部放电对油浸绝缘纸表面损伤特性研究[J].中国电机工程学报,2011,31(10):129-137.
Liao Ruijin,Yan Jiaming,Yang Lijun,et al.Characteristics of partial discharge-caused surface damage for oil-impregnated insulation paper[J].Proceedings of the CSEE,2011,31(10):129-137.
[16]马湘蓉,施卫,薛红,等.沿面闪络和丝状电流对光电导开关的老化机理[J].电工技术学报,2010,25(10):129-135.
Ma Xiangrong,Shi Wei,Xue Hong,et al.Injuring mechanism of surface flashover and filamention to the photoconductive switch[J].Transactions of China Electrotechnical Society,2010,25(10):129-135.
[17]黄伟民,邵涛,张东东,等.小型高压重复频率微秒脉冲电源及其放电应用[J].强激光与粒子束,2014,26(4):272-278.
Huang Weimin,Shao Tao,Zhang Dongdong,et al.A compact high voltage microsecond pulse power supply and its discharge application[J].High Power Laser and Particle Beams,2014,26(4):272-278.
[18]周中升,邵涛,章程,等.变压器油中绝缘介质沿面闪络的研究进展[J].绝缘材料,2014,47(4):1-5.
Zhou Zhongsheng,Shao Tao,Zhang Cheng,et al.Research progress in surface flashover of insulation dielectric in transformer oil[J].Insulating Materials,2014,47(4):1-5.
[19]周中升,章程,邵涛,等.纳秒脉冲下变压器油绝缘的击穿与闪络特性[J].高电压技术,2014,40 (10):3290-3296.
Zhou Zhongsheng,Zhang Cheng,Shao Tao,et al.Breakdown and flashover characteristics in transformer oil under nanosecond pulses[J].High Voltage Engineering,2014,40(10):3290-3296.
[20]陈玉,成永红,孙颖,等.指形电极结构设计及其对快脉冲真空闪络特性的影响[J].高电压技术,2009,35(4):761-765.
Chen Yu,Cheng Yonghong,Sun Ying,et al.Design of finger electrode configuration and its effect on pulsed vacuum flashover[J].High Voltage Engineering,2009,35(4):761-765.
[21]杨培中,蒋寿伟.表面粗糙度三维评定的研究[J].机械设计与研究,2002,18(2):64-67.
Yang Peizhong,Jiang Shouwei.The study on the 3D assessment of surface roughness[J].Machine Design and Research,2002,18(2):64-67.
[22]Krile J,Neuber A,Dickens J,et al.Imaging of dielectric surface flashover in atmospheric conditions[J].IEEE Transactions on Plasma Science,2005,33(2):270-271.
[23]Morales K P,Krile J T,Neuber A,et al.Pulsed dielectric surface flashover in nitrogen at atmospheric conditions[J].IEEE Transactions on Dielectrics and Electrical Insulation,2006,13(4):803-809.
[24]Choi K C,Kim H J,Shin B J.The effect of the discharge aging process on the surface state of MgO film in AC PDPs[J].IEEE Transactions on Electron Devices,2004,51(8):1241-1244.
[25]郎艳,王艺博,苏国强,等.表面粗糙度对有机玻璃材料真空沿面闪络特性的影响[J].高电压技术,2015,41(2):474-478.
Lang Yan,Wang Yibo,Su Guoqiang,et al.Influence of surface roughness on vacuum flashover characteristics of PMMA[J].High Voltage Engineering,2015,41(2):474-478.