1. Wind Power Research Center Shanghai Jiao Tong University Shanghai 200240 China 2. State Key Laboratory of Ocean Engineering Shanghai Jiao Tong University Shanghai 200240 China
Abstract:The paper briefly introduces the principle of flatness and flatness-based control. It sets up the dynamic equation of voltage source converter high voltage direct current (VSC-HVDC) and proves it is flat. Assuming the output current as flat output vector, a double loop control based on flatness is applied with VSC-HVDC. The outer loop generates the current reference according the requirement of targets. The inner loop outputs the control input for current by feed forward and feed back. Between them, the feed forward control comes from the relationship between flat output and flat input while the feed back control comes from the proportional integral controller for error. The simulation model of VSC-HVDC is set up by software, and the command step jumping and the grounded fault are simulated under the flatness-based control. The result shows the oscillation is smaller than that of the conventional cascade control. Finally, it concludes the flatness-based control can enhance the dynamic performance of VSC-HVDC.
何大清, 蔡旭. 基于平坦系统的VSC-HVDC控制[J]. 电工技术学报, 2012, 27(12): 233-239.
He Daqing, Cai Xu. Flatness-Based Control of VSC-HVDC. Transactions of China Electrotechnical Society, 2012, 27(12): 233-239.
[1] Bahrman M P, Johansson J G, Nilsson B A. Voltage source converter transmission technologies—the right fit for the application [C]. 2003 IEEE Power Engineering Society General Meeting, Toronto, Ont., Canada: IEEE, 2003, 3: 1840-1847. [2] Ruan S Y, Li G J, Peng L, et al. A nonlinear control for enhancing HVDC light transmission system stability[J]. International Journal of Electrical Power and Energy Systems, 2007, 29(7): 565-570. [3] 周国梁, 石新春, 魏晓光, 等. 电压源换流器高压直流输电不平衡控制策略研究[J]. 中国电机工程学报, 2008, 28(22): 137-143. [4] Ruan S Y, Li G J, Jiao X H, et al. Adaptive control design for VSC-HVDC systems based on backstepping method[J]. Electric Power Systems Research, 2007, 77(5-6): 559-565. [5] 郑超, 周孝信, 李若梅. 电压源换流器式高压直流输电的动态建模与暂态仿真[J]. 电网技术, 2005, 29(16): 1-5. [6] Jovcic D, Lamont L, Abbott K. Control system design for VSC transmission [J]. Electric Power Systems Research, 2007, 77(7): 721-729. [7] Fliess M, Levine J, Martin P, et al. Flatness and defect of non-linear systems: introductory theory and examples[J]. International Journal of Control, 1995, 61(6): 1327-1361. [8] Dannehl J, Fuchs F W. Flatness-based control of an induction machine fed via voltage source inverter—concept, control design and performance analysis[C]. IECON 2006-32nd Annual Conference on IEEE Industrial Electronics, Paris, France: IEEE, 2006, 10: 5125-5130. [9] Dannehl J, Fuchs F W. Flatness-based voltage- oriented control of three-phase PWM rectifiers[C]. The 13th International Power Electronics and Motion Control Conference, EPE-PEMC 2008, Poznan, Poland: 2008, 9: 444-450. [10] Song E, Lynch A F, Dinavahi V. Experimental validation of nonlinear control for a voltage source converter[J]. IEEE Transactions on Control Systems Technology, 2009, 17(5): 1135-1144. [11] Gensior A, Rudolph J, Guldner H. Flatness based control of three-phase boost rectifiers[C]. 2005 European Conference on Power Electronics and Applications, Dresden, Germany: IEEE, 2005, 9: 1665866. [12] Gensior A, Woywode O, Rudolph J, et al. On differential flatness, trajectory planning, observers, and stabilization for DC-DC converters [J]. IEEE Transactions on Circuits and Systems I: Regular Papers, 2006, 53(9): 2000-2010. [13] Hagenmeyer V, Delaleau E. Exact feedforward linearization based on differential flatness[J] International Journal of Control, 2003, 76(6): 537-556. [14] Cuiqing D, Sannino A, Bollen M H J. Analysis of the control algorithms of voltage-source converter HVDC [C]. 2005 IEEE Russia Power Tech, PowerTech, St. Petersburg, Russia: IEEE, 2005: 1-7. [15] 陈海荣, 徐政. 基于同步坐标变换的VSC-HVDC暂态模型及其控制器[J]. 电工技术学报, 2007, 22(2): 121-126. [16] 陈谦, 唐国庆, 胡铭. 采用dq0坐标的VSC-HVDC稳态模型与控制器设计[J]. 电力系统自动化, 2005, 28(16): 61-66.