Abstract:To extend the load variation range of Boost PFC converter operating in DCM and CCM, a novel PFC converter operating in pseudo continuous conduction mode (PCCM) is proposed. The operation of PCCM Boost converter is analyzed and its large signal model is established. Based on which, the digital valley current control strategy of current loop and PI compensation of voltage loop is designed. The PCCM Boost PFC converter can achieve high power factor over a wide load variation range. The performance of PCCM Boost PFC converter and CCM Boost PFC converter is verified and compared by using a 70~400W experimental prototype.
[1] Sebastian J, Cobos J A, Lopera J M, et al.The determination of the boundaries between continuous and discontinuous conduction modes in PWM DC-to-DC converters used as power factor preregulators[J]. IEEE Transactions on Power Electronics, 1995, 10(2): 574-582. [2] Tripathi R K, Das S P, Dubey G K. Mixed-mode operation of boost switch mode rectifier for wide range of load variations[J]. IEEE Transactions on Power Electronics, 2002, 17(6): 999-1009. [3] Rajesh Ghosh, Narayanan G. A single-phase boost rectifier system for wide range of load variations [J]. IEEE Transactions on Power Electronics, 2007, 22(2): 470-479. [4] Gusseme K D, Van de Sype D M, Van den Bossche A P, et al.Digitally controlled boost power factor correction converters operating in both continuous and discontinuous conduction mode[J]. IEEE Transactions on Industrial Electronics, 2005, 52(1): 88-97. [5] Ma Dongsheng, Ki Wing Hung.Fast transient PCCM switching converter with freewheel switching control[J]. IEEE Transactions on Circuits and Systems, 2007, 54(9): 2194-2197. [6] Kanakasabai Viswanathan, Ramesh Oruganti, Dipti Srinivasan.A novel tri-state boost converter with fast dynamics[J]. IEEE Transactions on Power Electronics, 2002, 17(5): 677-683. [7] Kanakasabai Viswanathan, Ramesh Oruganti, Dipti Srinivasan. Dual mode control of tri-state boost converter for improved performance[J]. IEEE Transactions on Power Electronics, 2005, 20(4): 790-797. [8] Xu Jianping. Modelling of switching DC-DC converters by timeaveraging equivalent circuit approach[J]. International Journal of Electronics, 1993:477-488. [9] Spiazzi G, Mattavelli P, Rossetto L. Methods to improve dynamic response of power factor preregulators: An overview[C]. Proceedings of the European Power Electronics Conference, 1995: 754-759. [10] Huliehel F A, Lee F C, Cho B H. Small signal modeling of the single phase boost high power factor converter with constant frequency control[C]. Proceedings of the Power Electronics Specialists Conference, 1992: 475-482. [11] Zhen Z Ye, Milan M Jovanovic.Implementation and performance evaluation of DSP based control for constant frequency discontinuous conduction mode Boost PFC front end[J]. IEEE Transactions on Industrial Electronics, 2005, 52(1): 98-107. [12] 马皓, 郎芸萍.一种关于单相Boost功率因数校正器数字控制的改进算法[J]. 电工技术学报, 2006, 21(2): 83-87. Ma Hao, Lang Yunping.An improved algorithm for DSP implementation of Boost PFC converter[J]. Transactions of China Electrotechnical Society, 2006, 21(2): 83-87. [13] Chen Jingquan, Prodic A, Erickson R W, et al.Pre- dictive digital current programmed control[J]. IEEE Transactions on Power Electronics, 2003, 18(1):411-419.